Category: printer

My 3D Printing Experience – Ultimaker 2

Unless you have been in a cave for the last decade you will have heard of the mystical technology that is 3D printing. A whole decade did you hear me say? Well actually, according to Wikipedia, 3D printing, or Additive Manufacturing,

I’m back!

Since the start of the year many of you have noticed that The Raspberry Pi Guy has not been as active as usual. Videos, tutorials, blog posts and everything else were put on a momentary hold for a very important

3D Printer Dilemma!

I am taking a small break from revision at the moment ;-). A much needed break I shall add! There is no doubt that nearly everyone has heard about the relatively new 3D printing revolution – if you haven’t heard